Electroknit Technical Information
From Antitronics
Contents |
Brother Electroknit KH-930E Technical information
Disk Drive/Computer Connection Notes
The external floppy drive for this machine was the same as a Tandy PDD1 (Portable Disk Drive 1). This drive is connected using a serial port. There is documentation on the internet about how to connect these drives to computers, but the connector pinout on the knitting machine is different than the drive, and I didn't find that documentation to be helpful.
I was able to figure out the connector pinout by examining the knitting machine PCB.
Knitting Machine/Computer Connection Notes
The knitting machine drive connection uses CMOS voltage levels, not RS-232.
Here is the pinout of the drive connector on the knitting machine:
_____
| |
______|___|______
| | | | |
| 7 | 5 | 3 | 1 |
|___|___|___|___|
| | | | |
| 8 | 6 | 4 | 2 |
|___|___|___|___|
The pin numbering is shown as they are labeled on the knitting machine PCB, and does not agree with other documents I found on the web.
| Connector Pinout | |||
| Pin | Signal | I/O | Notes |
|---|---|---|---|
| 1 | Ground | ||
| 2 | Out | Tied to 5, Pulled up through 1K resistor | |
| 3 | CTS? | In | (Tie to pin 2) |
| 4 | No Connection | ||
| 5 | Out | Tied to 2, Pulled up through 1K resistor | |
| 6 | RXD | In | |
| 7 | TXD | Out | |
| 8 | RTS? | Out | Follows state of Pin 3 (buffered) |
I have pulled pin 3 high, and am not using flow control in my software. I have not had problems with data loss while sending to the knitting machine, and the machine I am using is fast enough to always keep up with data received from the knitting machine. The data rate is 9600 bps, and the largest amount of data sent at once is 1024 bytes.
Here is the cable I am using to connect the knitter with a USB 9 pin serial port:
| Cable connections | |
| Knitter | 9 pin connector |
|---|---|
| 1 | 5 |
| 2 jump to 3 | |
| 6 | 3 |
| 7 | 2 |
Software Interface Information
There are a number of documents on the web about the Tandy PDD1 and the serial API for it, But they are all incomplete. The knitter places the drive into a mode called "FDC emulation Mode", which allows access to raw sectors. This document is the most complete documentation I was able to find:
External Disk Drive Emulator
I have written software that emulates the external disk. It runs under Linux and keeps the data as files on the linux file system. This allows knitting designs to be saved and restored using the emulation computer. I am using these files to reverse-engineer the knitting machine file format.
This software will be posted here very soon, after I do some final testing.
Knitting Machine File Format
Work on this continues. I have made some progress.
Related Links and Documents
I cannot vouch for the accuracy of these.
BL5 Brotherlink 5 serial or USB cable Brotherlink information
Yahoo group dedicated to hacking brother machines
Brother Liberation Front is working on open source interfaces
Info and protocols for the FB-100 interface
KE-100 motor drive (not sure that this is the right model drive for the KH-930E)
